Fitting the flap hinge - 2 hours

Fitting the hinge on the flap is fairly easy. After some time looking for the hinges that I tucked away 8 months ago, I finally found them and drug them out.
I used an edge marking tool to measure in 1/4" on each side as noted on the plans.

Next I clamped the hinge onto the flap assembly and checked that the line match up through the holes. After double checking that my hinge alignment was consistent with what is shown on the plans. I began to drill and cleco, re-checking alignment as I worked from the center to the ends.






Here is where my alignment ended up on the outboard rib.




and the other flap
 
 Well...Enough for the weekend. I am airplane'd out.