So one item that I've been delaying for quite some time was the stick boot rings. As usual like most things on the build is that it isn’t as bad as I thought.
I cut the required pieces of of some material I had sitting on the shelf. I then marked out the bend line, clamped them in the vice and bent the pieces by hand.
Next I drew reference lines on the plates and then set them on the seat pans and lined things up for the first holes. Drill and cleco!
Once it was all done, I then traced the control stick openings. I then found all of the center points to start drilling the radius corners of the cutouts.
I’ll cut these out tomorrow.
No comments:
Post a Comment