With the top cover position established. I now can figure out how I want the cover to fit over the pump and where I want the cover to end. I measured and marked out all of the bend points, cut relieve notches and then made all of the bends. A simple description but it was more tedious then that, I just don't want to mess this up. By the end of it, I was really happy with how the top cover was sitting and now I just need to start fitting the side covers.
I clamped them on, and started using a level to get things straight but soon found that a level is not going to work correctly as the centre tunnel is angled slightly and I want the cover to sit parallel with the pump. I'll stop here and come back to it when I can think it over a bit more.
No comments:
Post a Comment