Sunday, June 14, 2020

Fitting the firewall - 2 hours


Again, another short day in the garage today. I drew a line halfway on the F-601M-1 firewall angle. Then I managed to get the firewall supported via the wife’s ironing board and I got the firewall temporally clamped into place. First I lined up the second line of holes in the F-772 bottom skin with the centerline I had just drawn. 
 
I then started to measure the firewall and the measurement was a bit larger than 5/8” (just proud by about 1/32”). This seems to be in line with all other build logs out there. Looks like I will need to make some slight adjustments. 
 

No comments:

Post a Comment