I tried to put in another stellar day in on the HS.
Everything was going extremely well. I fitted the spars and ribs together.
Worked on the HS-710/714 angles. Cleco'd on the skin.
Began to fit the
HS-00005/00006 ribs. Finished the left side and began the right. Then I noticed
I made a terrible error. I drilled the hole fitting HS-00005 to HS-710 centered
in the angle, not 7/16" down. The hole is too high up and edge distance is
an issue. Silly mistake as I was going too fast. It only affects a few parts that I have to redo. Fortunately
I didn't drill that hole on the right side, so i'm still ok. Normally I'd be
quite ticked off.
No comments:
Post a Comment