Tuesday, September 8, 2015

Priming the trim tab - 1.5 hours

Well I received an email from Van's support saying not to worry about the oops dimple on the left elevator. He said to file out the crack, use a rivet in the hole were is was supposed to go, and he suggested I add a rivet between the two. So all is good. When I place a rivet one oblong hole, it is barely noticeable.

I spend an hour priming the trim tab parts. After a few hours drying time, I spent about a half an hour dimpling most of the trim tab pieces.


No comments:

Post a Comment