Worked on Rudder strips and VS Spar - 4 hours

I put in a decent day on the plane. I made the R-918 attach strips. It took a bit of time to fit them. I was careful to check and recheck fit to ensure that I had proper edge distances. This is one part that could cause some issue with the forward end. After all was said and done, the attach strips turned out well.

I then worked on cleaning up the edges on the R-710 horn brace. I was please will all the edge distances as well. It paid off to heed other builders warnings to not cut too much off on this part.

I then worked on the new VS-803PP spar and VS-808PP doubler.