I decided to use a cherry max rivet in this location. I used a Cherry Max rivet gauge to figure out that in need a CR3213-4-2 pull rivet. Of course I don't have those so I will have to put in an order for it.
Sunday, July 30, 2017
Installing aileron gap fairing - 2 hours
I decided to switch over to the wings as I had my fill of proseal. The aileron gap fairing need to be installed so I made short work of the riveting. However I notice that the last rivet next to the inboard aileron cannot be bucked/installed since there is such tight clearance to the aileron service bulletin reinforcement brace.
I decided to use a cherry max rivet in this location. I used a Cherry Max rivet gauge to figure out that in need a CR3213-4-2 pull rivet. Of course I don't have those so I will have to put in an order for it.
I decided to use a cherry max rivet in this location. I used a Cherry Max rivet gauge to figure out that in need a CR3213-4-2 pull rivet. Of course I don't have those so I will have to put in an order for it.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment