I was busy with work
today so not much happened with the practice projects. I did run over to
home depot and picked up materials so I could make a priming table and also
made the table for the DRDT-2 dimpler. I modified the design a bit from the
original plan. I made the table one piece that sat in the dimpler and is level
with the frame holder. My dimple dies measure 3/8" high so I will just
place my protective foam on the table and I will have the perfect height.
The priming frame is made up of 2"x3"s measuring 6'x3'. I then used my pneumatic stapler and stretched chicken wire over the frame. The idea is that I can prime most parts sitting on this frame and when I'm done I can put the frame up out of the way.
No comments:
Post a Comment